The Honeywell ART 2000 and ART 2100 are remote mounted weather avoidance radars R/T, primarily used for weather avoidance and ground mapping functions as an aid to navigation. These are high-performance modern radar that is proven reliable. But even simple things like getting in a hurry can have a huge impact during operation.
Honeywell issued Service Aid SA ART 2000-100 that describes operational methods to prevent potential problems.
When shutting down the radar system, turn the mode switch to STANDBY and then wait at least five (5) seconds before turning the switch to OFF. If the antenna does not have time to move to the center parked position, some noise and/or vibration may be noticeable when the system is turned off.
Failure to pause in the STANDBY position when turning the system off may cause the following problems if the system is rapidly turned back on:
Over time, observations have indicated that other problems may occur:
Honeywell Installation Bulletin 374 describes some precautionary measures to prevent damage to, or degradation of, the ART 2000/2100 high power digital weather radars.
These radars are specified to have an operating VSWR of up to 2:1. To prevent loss of performance, the following precautions are recommended:
This last point usually occurs inside a hangar, by transmitting into a close-by hangar door. This can cause a shorted T/R limiter, which results in weak returns. The damage may not be discovered until after take-off.
Following the proper operation and installation procedures and checking for the latest Service Aids for your equipment, can give you a greater and more dependable service life for your radar.
Not ready to upgrade to a GOGO AVANCE Solution? GOGO C1 keeps your aircraft connected
Do I Need An Avionics Service Plan During Heavy Maintenance?
Mandatory Service Bulletin Issued for Garmin G1000 Software Update
Ignoring Intermittent Flag Warnings On The Altimeter Is A Bad Habit
Do Not Delay. The Universal Avionics FMS GPS Rollover Software Update Is Only Months Away