The ramping of environmental water towards an exit point has always been a challenge. Careful inspection of susceptible areas will ensure unwanted corrosion won’t set in…
Read More...
Hot weather is coming up. Having your Falcon 900 series aircraft cooling system at top performance is not just a convenience but can save you money in the future.
Read More...
Is it normal for outboard slats not to retract fully after winglet installation on a Falcon 900? Keep reading for the answer.
Read More...
Because of the high probability of future corrosion around the fasteners of the front center panel ahead of frame 10, Duncan Aviation strongly recommends to comply with SB 392.
Read More...
The wiring harnesses for nose wheel anti-skid transducers are known to break down internally which can cause intermittent anti-skid issues.
Read More...
These standoff brackets have a tendency to crack if the aft door rubber bumper stop is out of adjustment.
Read More...
During the removal and replacement of the flap drive 90° gear boxes, pay particular attention to the orientation of the mounts attaching the gearboxes to the aft spar.
Read More...
When removing the over-the-wing anti-ice lines during the Falcon C inspection, watch for corrosion on the clamps and tubing holding the left-hand and right-hand peri-seal heat shields in place
Read More...